1. ZT173YMM right crankcase cover B (with oil plug)
|
|
|
|
|
|
|
Quantity
|
|
|
1
|
|
Remarks: Only contain oil plug. Please check the clutch lever seat of the left hand to confirm the same status and then place the order. The clutch will be improved from September 10, 2018. The part needs to be unified with the clutch rocker to be used normally.
|
|
|
|
2. FB12×18×5 fluorine rubber seal
|
|
|
|
|
|
|
Quantity
|
|
|
1
|
|
Remarks: Confirm you have ability to assemble and place orders
|
|
|
|
3. GB290-HK1210 needle rolling bearing
|
|
|
|
|
|
|
Quantity
|
|
|
2
|
|
Remarks: Confirm you have ability to assemble and place orders
|
|
|
|
4. FB14×22×5 Hydrogenated nitrile oil seal.
|
|
|
|
|
|
|
Quantity
|
|
|
1
|
|
Remarks:Be sure to confirm that you have ability to assemble it and then you place an order.
|
|
|
|
5. type hole circlip φ24×1
|
|
|
|
|
|
|
Quantity
|
|
|
1
|
|
Remarks:Be sure to confirm that you have ability to assemble it and then you place an order.
|
|
|
|
6. Non-standard M6×25.5 double-head 9.8 studs bolts (environmental color Zinc)
|
|
|
|
|
|
|
Quantity
|
|
|
2
|
|
Remarks: ① and ② of the old model have been discontinued. If you need to replace the old double-headed studs, you must purchase them in pairs. "1251300-096000 Non-standard cover-shaped 9-grade nut M6×13 (environmentally protection color zinc)"; if it is ①, and it needs to chamfer 1.5~2 on the fine filter cover before assembly.This stud cannot be used in the engine cylinder head of the 200 model.
|
|
|
|
7. Non-standard cover type 9 degree nut M6×13 (environmental color Zinc)
|
|
|
|
|
|
|
Quantity
|
|
|
3
|
|
Remarks:0# Sleeve. This is a new, taller nut. If you need to replace the stud, you must purchase this taller nut at the same time. This nut can replace the old, shorter nut, and for the sake of uniformity, it is recommended to replace them simultaneously. For water-cooled series models such as KD150-U/G1/Z2, the standard torque is 10N ± 1.5N.m; for series models such as ZT310, ZT350, ZT250-S/R, it is 12N ± 1.5N.m; for ZT310T-M, it is 10N ± 1N.m. Starting from February 19, 2025, the two nuts at the ECU installation location of ZT350-V1/VX/S will be switched to this model, and the original nuts will be phased out. It is recommended to purchase 2 pieces for replacement at the same time.
|
|
|
|