1. ZT173YMM right crankcase cover sub-assembly B
|
|
|
|
|
|
|
Quantity
|
|
|
1
|
|
Remarks: Please check the left hanglebar clutch rocker arm to confirm the status and then place the orders. From September 10, 2018, the clutch was improved. This part needs to be unified with the clutch rocker arm to be used normally.
|
|
|
|
2. Non-standard cover type 9 degree nut M6×13 (environmental color Zinc)
|
|
|
|
|
|
|
Quantity
|
|
|
1
|
|
Remarks:0# Sleeve. This is a new, taller nut. If you need to replace the stud, you must purchase this taller nut at the same time. This nut can replace the old, shorter nut, and for the sake of uniformity, it is recommended to replace them simultaneously. For water-cooled series models such as KD150-U/G1/Z2, the standard torque is 10N ± 1.5N.m; for series models such as ZT310, ZT350, ZT250-S/R, it is 12N ± 1.5N.m; for ZT310T-M, it is 10N ± 1N.m. Starting from February 19, 2025, the two nuts at the ECU installation location of ZT350-V1/VX/S will be switched to this model, and the original nuts will be phased out. It is recommended to purchase 2 pieces for replacement at the same time.
|
|
|
|
3. GB16674 M6×45 Hex flange flange bolt (9.8 grade/environmental color Zinc)
|
|
|
|
|
|
|
|
4. GB16674 M6×30 Hexagon flange bolts (9.8 grade/environmental color Zinc)
|
|
|
|
|
|
|
|
5. GB16674 M6×75 Hexagon flange bolts (9.8 grade/environmental color Zinc)
|
|
|
|
|
|
|
|
6. ZT173YMM clutch digging cable support
|
|
|
|
|
|
|
|
7. 6.3×12×1.6 copper gasket
|
|
|
|
|
|
|
|
8. ZT173YMM right crankcase cover cushion piece
|
|
|
|
|
|
|
Quantity
|
|
|
1
|
|
Remarks: The gasket of ZT173YMM right crankcase cover is a disposable seal, which needs to be replaced every time it is disassembled.
|
|
|
|